If you aren't happy with the length of your kitchen faucet's hose, you can extend it by simply disconnecting it from the faucet. To do so, use a basin wrench to loosen the lock nut. Carefully hold the copper tubing in one hand while loosening the nut with the other. Don't overtighten the nut, as it can break or twist.

Using a measuring tape, you can determine the exact length of the supply line. This way, you can ensure that you'll have enough hose to reach your new location. You can also see how long the gap between the two points is. This way, you'll be able to purchase the right materials when you need them. To begin, remove the compression coupling from the faucet. You should then follow the steps described above.

Once you've done this, you can install the new hose to your faucet. The new one should be at least 1/2 inch in diameter. The new one should be of a similar diameter, which will save you some money. Purchasing a new one can cost as much as $250, so it's a good idea to save a few bucks before calling a plumber. If you're not comfortable installing a new hose, you can try repairing the old one by tightening the valve nut and applying Teflon tape.

In case you want to add an accessory, you should first replace the kitchen faucet. Before you do this, make sure that you clean the sides of the faucet and place a towel to collect the water dripping out from the pipe. Afterwards, install the supply line extender. If you've installed the new hose, it's important to clean the area underneath the faucet. Also, be sure to use a basin wrench to connect the new one to the faucet.

Make sure the water faucet is completely shut off before you attach the new hose. Depending on your model, you may not have separate shutoff valves for hot and cold water. You must also label the hot and cold extenders with their respective numbers. Make sure to use thread sealant on any threaded parts. Finally, you need to install the tailpieces into the countertop holes. Once you have finished this step, you can disconnect the hose from the faucet and reattach it.

Usually, faucet supply lines are too short. Extending them will eat up space underneath the sink and may cause it to become kinked and broken. Extra-long supply lines can also delay the arrival of hot water in the sink. This occurs because the water in the line will cool down over time, and then move out of the way of freshly heated water. Then, your faucet's water supply will be delayed until you unclog it.

The easiest way to extend the industrial kitchen faucet hose is to purchase a flexible extension. It will require only a few minutes of your time and doesn't require a professional. Whether you are a DIY novice or a handyman, this project should be relatively easy. Just be sure you follow the instructions carefully. If you're unsure of how to do it, Google it to get the instructions. It should take no more than a few minutes.